About the ICS Code:
The ICS (International Classification for Standards) is a scheme much like the Dewey Decimal System.
Use it to find standards that are grouped by subject matter.
Back to ICS Index.
29.030: Magnetic materials
Level 1: 29 (ELECTRICAL ENGINEERING)
The following documents are a part of this series:
ASTM:
- ASTM-A1036 - Standard Guide for Measuring Power Frequency Magnetic Properties of Flat-Rolled Electrical Steels Using Small Single Sheet Testers
- ASTM-A1054 - Standard Specification for Sintered Ceramic Ferrite Permanent Magnets
- ASTM-A34 - Standard Practice for Sampling and Procurement Testing of Magnetic Materials
- ASTM-A340 - Standard Terminology of Symbols and Definitions Relating to Magnetic Testing
- ASTM-A341 - Standard Test Method for Direct Current Magnetic Properties of Materials Using D-C Permeameters and the Ballistic Test Methods
- ASTM-A342 - Standard Test Methods for Permeability of Feebly Magnetic Materials
- ASTM-A348 - Standard Test Method for Alternating Current Magnetic Properties of Materials Using the Wattmeter-Ammeter-Voltmeter Method, 100 to 10 000 Hz and 25-cm Epstein Frame
- ASTM-A596 - Standard Test Method for Direct-Current Magnetic Properties of Materials Using the Ballistic Method and Ring Specimens
- ASTM-A719 - Standard Test Method for Lamination Factor of Magnetic Materials
- ASTM-A772 - Standard Test Method for AC Magnetic Permeability of Materials Using Sinusoidal Current
- ASTM-A773 - Standard Test Method for dc Magnetic Properties of Materials Using Ring and Permeameter Procedures with dc Electronic Hysteresigraphs
- ASTM-A889 - Standard Test Method for Alternating-Current Magnetic Properties of Materials at Low Magnetic Flux Density Using the Voltmeter-Ammeter-Wattmeter-Varmeter Method and 25-cm Epstein Frame
- ASTM-A893 - Standard Test Method for Complex Dielectric Constant of Nonmetallic Magnetic Materials at Microwave Frequencies
- ASTM-A894 - Standard Test Method for Saturation Magnetization or Induction of Nonmetallic Magnetic Materials
- ASTM-A900 - Standard Test Method for Lamination Factor of Amorphous Magnetic Strip
- ASTM-A977 - Standard Test Method for Magnetic Properties of High-Coercivity Permanent Magnet Materials Using Hysteresigraphs
BSI:
- BS-6404-8.1 - Magnetic materials. Individual materials. Magnetically hard materials
- BS-EN-10251 - Magnetic materials. Methods of determination of the geometrical characteristics of electrical steel sheet and strip
- BS-EN-10280 - Magnetic materials. Methods of measurement of the magnetic properties of electrical sheet and strip by means of a single sheet tester
- BS-EN-10282 - Magnetic materials. Method of test for the determination of surface insulation resistance of electrical sheet and strip
- BS-EN-10304 - Magnetic materials (iron and steel) for use in relays
- BS-EN-10330 - Magnetic materials. Method of measurement of the coercivity of magnetic materials in an open circuit
- BS-EN-10331 - Magnetic materials. Specification for sintered soft magnetic materials
- BS-EN-10342 - Magnetic materials. Classification of surface insulations of electrical steel sheet, strip and laminations
- BS-EN-60404-13 - Magnetic materials. Methods of measurement of density, resistivity and stacking factor of electrical steel sheet and strip
- BS-EN-60404-2 - Magnetic materials. Methods of measurement of the magnetic properties of electrical steel strip and sheet by means of an Epstein frame
- BS-EN-60404-4 - Magnetic materials. Methods of measurement of d.c. magnetic properties of magnetically soft materials
- BS-EN-60404-5 - Magnetic materials. Permanent magnet (magnetically hard) materials. Methods of measurement of magnetic properties
- BS-EN-60404-8-6 - Magnetic materials. Specifications for individual materials. Soft magnetic metallic materials
- BS-EN-60424-1 - Guidance of the limits of surface irregularities of ferrite cores. General specification
- BS-EN-60424-3 - Guidance of the limits of surface irregularities of ferrite cores. ETD-cores and E-cores
- BS-IEC-60404-1 - Magnetic materials. Classification
- PD-IEC-62331 - Pulsed field magnetometry
- PD-IEC-62383 - Determination of magnetic loss under magnetic polarization waveforms including higher harmonic components. Measurement, modelling and calculation methods
- PD-IEC-62517 - Magnetizing behaviour of permanent magnets
IEC:
- IEC-1333 - Marking on U and E ferrite cores
- IEC-1609 - Microwave ferrite components - Guide for the drafting of specifications
- IEC-404-10 - Magnetic materials. Part 10: Methods of measurement of magnetic properties of magnetic sheet and strip at medium frequencies
- IEC-404-12 - Magnetic materials - Part 12: Guide to methods of assessment of temperature capability of interlaminar insulation coatings
- IEC-404-13 - Magnetic materials - Part 13: Methods of measurement of density, resistivity and stacking factor of electrical steel sheet and strip
- IEC-404-5 - Magnetic materials - Part 5: Permanent magnet (magnetically hard) materials - Methods of measurement of magnetic properties
- IEC-404-8-5 - Magnetic materials. Part 8: Specifications for individual materials. Section Five: Specification for steel sheet and strip with specified mechanical properties and magnetic permeability
- IEC-404-8-9 - Magnetic materials - Part 8: Specifications for individual materials - Section 9: Standard specification for sintered soft magnetic materials
- IEC-60050-221-3 - Amendment 3 - International Electrotechnical Vocabulary - Part 221: Magnetic materials and components
- IEC-60404-1 - Magnetic materials - Part 1: Classification
- IEC-60404-1-1 - Magnetic materials - Part 1-1: Classification - Surface insulations of electrical steel sheet, strip and laminations
- IEC-60404-11 - Magnetic Materials - Part 11: Method Of Test For The Determination Of Surface Insulation Resistance Of Magnetic Sheet And Strip
- IEC-60404-2 - Magnetic materials - Part 2: Methods of measurement of the magnetic properties of electrical steel strip and sheet by means of an Epstein frame
- IEC-60404-3 - Magnetic materials - Part 3: Methods of measurement of the magnetic properties of electrical steel strip and sheet by means of a single sheet tester
- IEC-60404-4 - Magnetic materials - Part 4: Methods of measurement of d.c. magnetic properties of magnetically soft materials
- IEC-60404-5-1 - Amendment 1 - Magnetic materials - Part 5: Permanent magnet (magnetically hard) materials - Methods of measurement of magnetic properties
- IEC-60404-6 - Magnetic materials - Part 6: Methods of measurement of the magnetic properties of magnetically soft metallic and powder materials at frequencies in the range 20 Hz to 200 kHz by the use of ring specimens
- IEC-60404-6 - Magnetic materials - Part 6: Methods of measurement of the magnetic properties of magnetically soft metallic and powder materials at frequencies in the range 20 Hz to 200 kHz by the use of ring specimens
- IEC-60404-8-1 - Magnetic materials - Part 8-1: Specifications for individual materials - Magnetically hard materials
- IEC-60404-8-10 - Magnetic materials - Part 8-10: Specifications for individual materials - Magnetic materials (iron and steel) for use in relays
- IEC-60404-8-3 - Magnetic materials - Part 8-3: Specifications for individual materials - Cold-rolled electrical non-alloyed and alloyed steel sheet and strip delivered in the semi-processed state
- IEC-60404-8-4 - Magnetic materials - Part 8-4: Specifications for individual materials - Cold-rolled non-oriented electrical steel sheet and strip delivered in the fully-processed state
- IEC-60404-8-6 - Magnetic materials - Part 8-6: Specifications for individual materials - Soft magnetic metallic materials
- IEC-60404-8-7 - Magnetic materials - Part 8-7: Specifications for individual materials - Cold-rolled grain-oriented electrical steel strip and sheet delivered in the fully-processed state
- IEC-62331 - Pulsed field magnetometry
- IEC-62517 - Magnetizing behaviour of permanent magnets
- IEC-62518 - Rare earth sintered magnets - Stability of the magnetic properties at elevated temperatures
- IEC-62581 - Electrical steel - Methods of measurement of the magnetostriction characteristics by means of single sheet and Epstein test specimens