ASTM-C33 revision history is available.
|ASTM Identifier||ASTM C33/C33M 13|
|Revision Number||2013 EDITION|
|Title||Standard Specification for Concrete Aggregates|
|Publication Date||Jan. 1, 2013, midnight|
|Changes from the previous issue||A redline edition is available for this document, with all changes visible. Ask Document Center Inc. for more information (http://www.document-center.com/).|
1.1 This specification defines the requirements for grading and quality of fine and coarse aggregate (other than lightweight or heavyweight aggregate) for use in concrete.2
Note 1—This specification is regarded as adequate to ensure satisfactory materials for most concrete. It is recognized that, for certain work or in certain regions, it may be either more or less restrictive than needed. For example, where aesthetics are important, more restrictive limits may be considered regarding impurities that would stain the concrete surface. The specifier should ascertain that aggregates specified are or can be made available in the area of the work, with regard to grading, physical, or chemical properties, or combination thereof.
1.3 This specification is also for use in project specifications to define the quality of aggregate, the nominal maximum size of the aggregate, and other specific grading requirements. Those responsible for selecting the proportions for the concrete mixture shall have the responsibility of determining the proportions of fine and coarse aggregate and the addition of blending aggregate sizes if required or approved.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
|Keywords||aggregates; coarse aggregate; concrete aggregates; fine aggregate ; ICS Number Code 91.100.30 (Concrete and concrete products)|
This specification defines the requirements for grading and quality of fine and coarse aggregate for use in concrete. Fine aggregate shall consist of natural sand, manufactured sand, or a combination thereof. Fine aggregate shall be free of injurious amounts of organic impurities. Fine aggregate for use in concrete that will be subject to wetting, extended exposure to humid atmosphere, or contact with moist ground shall not contain any materials that are deleteriously reactive with the alkalis in the cement in amount sufficient to cause excessive expansion of mortar or concrete. Fine aggregate subjected to five cycles of the soundness test shall have a required weighted average loss. Coarse aggregate shall consist of gravel, crushed gravel, crushed stone, air-cooled blast furnace slag, or crushed hydraulic-cement concrete, or a combination thereof. The sampling and test methods shall be done with grading and fineness modulus test, organic impurities test, effect of organic impurities on strength test, soundness test, clay lumps and friable particles test, coal and lignite test, bulk density of slag test, abrasion of coarse aggregate test, reactive aggregate test, freezing and thawing test, and chert test method.
|To find similar documents by ASTM Volume:||
04.02 (Concrete and Aggregates)|
|To find similar documents by classification:||
91.100.30 (Concrete and concrete products)|
Purchase ASTM-C33 from Document Center Inc.
If you have questions about this document or other standards, please contact us at:
Document Center Inc.
121 Industrial Road Suite 8
Belmont CA 94002